Dmx-Controlled Operation; Addressing The Projector; Choosing Functions And Parameters; Dmx-Protocol - EuroLite LED FLO-4 DMX-Lichteffekt Bedienungsanleitung

Press the FUNC–button again. The display shows FD:xx. Use the UP and DOWN buttons to set fade time
values.

DMX-Controlled Operation

Press the MODE button to select DMX Mode. Under this point of the menu, you can select between six DMX
modes. In DMX Mode, the DMX LED indicator lights up.
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

Addressing the Projector

The Control Board on your DMX-controller allows you to assign the DMX fixture address, which is defined as
the first channel from which the LED Flo-4 DMX will respond to the controller.
In DMX Mode the display shows "A001". Set the desired address via the UP/DOWN buttons. The „-„ in front
of the „Axxx" flashes as soon as data is received.
Controlling:
After having addressed the LED Flo-4 DMX device(s), you may now start operating these via your lighting
controller.

Choosing Functions and Parameters

Press the FUNC button to select the desired DMX Mode.
The desired parameter values can be selected with the UP or DOWN buttons.
DMX MODE
D-:P1
D-:P2
D-:P3
D-:P4
D-:P5
D-:P6
Note: To change from one DMX Mode to another, it is recommended to switch the device off and then on
again.

DMX-Protocol

D-:P1: 12 Channel-Occupation
D-:P1 Red
Channel
Spot 1 1
Spot 2 4
Spot 3 7
Spot 4 10
DESCRIPTION
12 channel-occupation
14 channel-occupation
8 channel-occupation
3 channel-occupation
1 channel-occupation
5 channel-occupation
Green Blue
Channel Channel
2 3
5 6
8 9
11 12
22/47 00025815.DOC, Version 1.0