Connection To The Power Supply - Notes For The Installer; Connection Conditions; Connecting To The Mains - hanseatic 2013C(G)3.334eETsDpHbB Gebrauchsanleitung

28 mm
15
(f)
6. Use the supplied retaining clamps to fix
the hob in place to prevent it from slipping.
Screw the 4 retaining clamps into the
hob from beneath and affix it in the work
surface with the help of gentle hammer
strokes.
Connection to the power
supply – notes for the installer
WARNING
Risk of electric shock / fi re hazard!
Improperly installed electrical connec-
tions can cause electrical shocks and/or
short circuits.
Connection to the mains supply may
■
only be made by an authorised elec-
trician approved by the local energy
supply company, e.g. our Service Cen-
tre (see page EN-36). Only then will
you benefi t from our warranty and a
suffi cient level of safety.
Since all poles of the appliance can-
■
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cat-
egory III must be connected within
the house installation with at least 3
mm contact clearance; this includes
fuses, miniature circuit breakers and
protective devices.
(g)
Fitting and installation

Connection conditions

The oven is designed for the following alter-
nating voltages:
– 230 V 1N~ / 50 Hz, 40 A
– 400 V 2N~ / 50 Hz, 25 A
– 400 V 3N~ / 50 Hz, 16 A
– A separate power supply is required.
– The power cord used must comply with
the requirements of DIN EN 60335-1 (e.g.
H05RR-F model).
– Depending on the type of connection, the
conductor cross-section must be selected
and the contact bridges inserted or re-
moved (see following figures).
– When connecting the appliance, VDE re-
quirements and the "Technical connection
requirements" must be observed.
Contact protection must be guaranteed.

Connecting to the mains

The terminal block and connection diagrams
can be found on the rear side of the oven.
1. Before accessing the terminals, switch
off all supply circuits and secure them
against being switched on again.
2. Make sure that all poles of the connection
cables are disconnected and that effec-
tive earthing is possible.
3. Connect the leads and, if necessary,
the enclosed brass bridges to the corre-
sponding contact terminals of the cooker
power connection in accordance with the
circuit diagrams shown here.
4. Lay the connection cable behind the
cooker so that it does not touch the rear
wall of the cooker. The rear cooker wall
becomes hot while it is in use.
Page EN-31