Error Messages - Vicon RS-ED 825 Betriebsanleitung

UK
6.

ERROR MESSAGES

Error messages generated by the system will automatically disappear when the cause has been remedied. Error
messages can be suppressed by pressing
LEFT STUCK
RIGHT STUCK
LEFT STUCK
RIGHT STUCK
DRIFTING LEFT
DRIFTING RIGHT
SPEED TOO HIGH
SPEED TOO LOW
BATTERY LOW
MEMORY ERROR
NOTE: The actuators must be calibrated again as well as the wheel sensor or radar.
or .
Left-hand actuator stuck during opening or no actuator connected
<-
during spreading. No power on machine casing.
Right-hand actuator stuck during opening or no actuator connected
->
during spreading. No power on machine casing.
Left-hand actuator stuck during closing or no actuator connected
->
during spreading. No power on machine casing.
Right-hand actuator stuck during closing or no actuator connected
<-
during spreading. No power on machine casing.
Left-hand actuator shifts at idle.
Right-hand actuator shifts at idle.
Speed too high, cannot increase output further.
Speed too low (below limit value).
Battery voltage too low (9 Volts).
This error will not occur under normal circumstances. Should an error
in the computer's storage system occur, the default setting will be
used. This will remain on the screen until any key is pressed. Then
the default values will be set.
49