Empty Hopper; Language Function; Buzzer Function; Contrast Function - Vicon RS-ED 825 Betriebsanleitung

UK

2.4.1 Empty hopper:

After pressing , the metering openings of the hopper will fully open. The display shows a shifting circle,
indicating that the hopper is being emptied.
Emptying the hopper will stop after you press
NOTE: If the left-hand or right-hand side of the hopper has been shut off in the main menu using
that side will also remain shut when emptying the hopper.

2.4.2 Language function:

With this function you can choose the language used in the menus by pressing

2.4.3 Buzzer function:

The buzzer volume can be increased or decreased by pressing

2.4.4 Contrast function:

The display contrast can be set by pressing

2.4.5 Calibration distance:

With this function you can change the distance for the wheel calibration to calibrate the wheel pulses at a different
distance.
NOTE: If you change this value, you must carry out a wheel calibration.

2.4.6 Wheel calibration :

This shows the number of pulses of the most recent wheel calibration. You can start the wheel calibration by
pressing . See 3.1.4.

2.4.7 Wheel/radar selection:

Here you can enter whether the machine is equipped with a wheel sensor or a radar unit. Make your choice by
pressing and

2.4.8 Radar pulses:

Here you can enter the number of pulses per metre for the radar. This value cannot be calibrated, but is stated by
the radar manufacturer. Make your choice by pressing

2.4.9 Side calibration test:

With this function you can select a side for the calibration test. By default this is the right-hand side. Make your
choice with and
36
EMPTY HOPPER
LANG=
BUZZER=
CONTRAST=
CAL. DIST.=
CAL. WHEEL=
INPUT=
and confirm with .
RAD. PULSES.=
CAL.=
and confirm with .
.
ENG
80%
and
75%
and . Confirm with
20m
200
WHEEL
130
and and confirm with
RIGHT
and . Confirm with
. Confirm with .
.
.
or , then
.