Speed Simulation; Battery Voltage; Last Function; Resetting The Default Values Of The Ed 825 - Vicon RS-ED 825 Betriebsanleitung

UK

2.4.10 Speed simulation:

If a speed has been entered in this menu, the spreader will use that speed instead of the wheel sensor value. It will
be obvious that the speed-controlled application will not function in that case. Make your choice by pressing
and and confirm with
NOTE: Make sure that this speed is set to zero when you start using the wheel sensor again.

2.4.11 Battery voltage:

This shows the battery voltage of the tractor. It must be at least 9 Volt.

2.4.12 Last function:

This indicates that you have browsed through the entire menu. When you press
selection menu will reappear. You can leave the selection menu by pressing one of the four readout keys.
2.5

Resetting the default values of the ED 825

It may happen that you want to reset the ED 825 fully to the original default values. You can do that by
simultaneously pressing
NOTE: Then first put the switch on the control box off and on before proceeding.
NOTE: When you have done that, the actuators must be calibrated again, see 4.2.1. The same applies to the
wheel sensor or radar, see 3.1.4.
SPEED=
.
BATTERY=
LAST FUNCTION
, and directly after switching on the control box.
0.0
13.8V
again, the start of the
37