Entering A New Value; The Selection Menu - Vicon RS-ED 825 Betriebsanleitung

UK
2.3

Entering a new value

If a value must be changed, for instance the application rate or the working width, you can use the
As soon as a value has been changed by pressing
also blink to show that the change can be confirmed by pressing this key.
NOTE: If the value is not confirmed with
The keys are operated as follows.
or Every time you press one of these keys the value is respectively raised or lowered by 1. When you
keep the key pressed down, the value will remain increasing in steps of 1 until you release it.
Reset the factory-set minimum.
and You can reset the default setting for the value in question by pressing these keys simultaneously.
A new or modified value will not be stored in the memory until
(other than referred to above) will end the input without storing the new value in the memory. The old
value reappears on the display. The display will no longer blink.
During spreading you can only change the over/underapplication by the preset increment value. All other values
can only be changed when the spreader is stopped.
2.4

The selection menu

Pressing takes you to the selection menu. Every time you press
can leave the menu by pressing one of the readout keys.
The first screen is:
This is the readout of the spreading disc rpm.
Pressing once more takes you to the next readout. The display will show the preset working width of the
spreader.
The spreader working width can be set with
CAUTION: The working width must always be set as the full working width of the spreader with both sides.
When one side is shut off, the computer will take that into account. However, the screen will always
display the full working width.
NOTE: Be sure to use the spreading disc speed listed in the spreading tables for the set working width.
The menus below are function menus which are used to enter machine settings. These functions are not
available during spreading.
The screen shows
menus are function menus.
or
, the old value will be restored.
RPM=
WIDTH=
, and
FUNCTION
, it will start to blink. The indicator light above
is pressed. Pressing any other key
the next menu screen will appear. You
0
24m
.
to indicate that the following
or key.
will
35