Vicon RS-ED 825 Betriebsanleitung Seite 43

UK
- Enter this weight on the control box using
- Press . The following text appears on the screen as start of calibration test 2:
- Press to continue. The following text will appear on the screen:
- Start the tractor and switch on the pto at the correct rpm for your spreader and working width. Refer to the
manual and the spreading table.
- Carry out calibration test 2 as described at test 1. Enter the calibration value using
.
- Press to continue. The following text will appear on the screen:
NOTE: For accurate metering we recommend to carry out at least TWO calibration tests at position CAL. 1 and
TWO calibration tests at position CAL.2.
- Press if you want to perform the calibration procedure once more. Press
and to start spreading.
If you press the calibration procedure starts again and the average over the TWO weights (for positions CAL.1
and CAL.2) will be calculated.
NOTE: If the application rate (in kg/ha), working width or forward speed for the same fertiliser on the same day
changes to such an extent that you pass the 70 kg/min limit, then switch fine metering on or off. Use the
correct calibration values!
, and confirm with
CAL. 2 TIME =
WEIGHT 2=
CAL. AGAIN ?
.
20 s
xx.x kg
to leave the calibration menu
or and confirm with
41