Spreading; Over/Underapplication - Vicon RS-ED 825 Betriebsanleitung

UK
3.2

Spreading

When the operating data have been entered correctly, you can start spreading.
- Switch on the pto shaft at the correct rpm (refer to manual and spreading table).
- Start driving at a speed of at least 2 km/h.
- Press to start spreading.
- Press to stop spreading.
During and after spreading the following values can be read out:
1 the current forward speed through
2 the number of hectares spread through
3 the total distance through
4 the set application rate through
5 the disc rpm through
6 the set working width through
When you start spreading you can reset the hectare counter and distance counter by pressing
relevant functions. The hectare counter only registers during spreading, unlike the distance covered which is also
registered when you are not spreading.
3.3

Over/underapplication

During spreading the application rate can be increased or decreased by pressing
number of kilos by which the preset application is increased or decreased.
Press or to increase or decrease this value by the present increment size. The red indicator light above the
key warns you that over/underapplication is active.
CAUTION: This change will have an immediate effect on the application rate and it is not necessary to
confirm with
NOTE: When you have pressed
over/underapplication again.
The red lamp above
. Then you can press
44
;
;
;
;
;
Kg/Ha=
.
and subsequently you resume spreading, the spreader will directly start
stays on. To switch off this function, press
to start spreading at the regular preset spreading rate.
;
400+0
. The display will show the
and set the value on 0 by using
and within the
, or