Operation; Changing/Inserting The Tool/Collet Chuck - Parkside PDSS 16 A1 Originalbetriebsanleitung

CAUTION!
► Ensure that the compressed air hose is firmly attached. A loose
hose can thrash about uncontrollably causing grave danger.
Likewise, ensure the firm seat of the two screw connections
between the coupling piece and the appliance.
♦ The compressed air source must be equipped with a pressure re-
ducer so that you can regulate the air pressure.

Operation

Changing/inserting the tool/collet chuck

CAUTION!
► The shaft diameter of the tool must exactly match the clamp
bore of the collet chuck
♦ Hold the spindle
♦ Unscrew the collet chuck nut
bly tool .
♦ Insert the tool into the collet chuck
♦ Hold the spindle
♦ Tighten the collet chuck nut
■ Ensure the accessory tool is firmly attached.
CAUTION!
► If no tool is inserted into the collet chuck
tighten the collet chuck nut
it on by hand only!
PDSS 16 A1
/ (Ø 6.35 mm / 3.2mm)!
using the assembly tool
from the thread using the assem-
using the assembly tool
using the assembly tool
with the assembly tool
.
/ .
.
/ , do not
GB │ IE
.
, screw
│
47 ■