Parkside PDSS 16 A1 Originalbetriebsanleitung Seite 42

■ The permissible speed of the accessory tool used must be at least
as high as the maximum speed specified for the compressed air
tool. Accessories that rotate faster than the permissible rate can
break and throw pieces into the air.
■ Never fit a grinding disc, cutting disc or milling cutter. A bursting
grinding disc can lead to serious injuries or death.
■ Do not use discs that are damaged, cracked or have been
dropped.
■ Only approved accessory tools with the appropriate shaft diame-
ter may be used.
■ Observe the manufacturer's recommendation for small grinding
tools. The maximum permissible protrusion (L0 = length of the
shaft between the collet chuck end and the small grinding tool)
specified by the manufacturer must not be exceeded when using
small grinding tools! If the protrusion (L0) is increased, the permis-
sible rotation speed must be lowered. Wherever possible, insert
the complete length of the shaft of the accessory tool into the col-
let chuck. Ensure that the clamping length (Lg) is at least 10 mm.
■ The shaft diameter of the accessory tool must exactly match the
clamp bore of the collet chuck!
PDSS 16 A1
L o L
g
GB │ IE │
39 ■