Before Use; Fitting The Connector Nipple; Lubrication - Parkside PDSS 16 A1 Originalbetriebsanleitung

Before use

NOTE
► The compressed air tool may only be operated using cleaned,
oil-atomised compressed air and the maximum operating pres-
sure of 6.3 bar must not be exceeded on the appliance. The
compressor must be fitted with a pressure reducer to regulate
the working pressure.
► Wind the supplied Teflon tape
tors.

Fitting the connector nipple

♦ Wrap the threads on the connector nipple
Teflon tape
♦ Screw the connector nipple

Lubrication

NOTE
► Regular lubrication is particularly important to avoid friction
and corrosion damage. We recommend using a suitable
special oil for compressed air tools (e.g. Liqui Moly compressor
oil).
–
Lubrication with mist oiler
A mist oiler (not supplied) continuously and optimally
lubricates the appliance as a preparation stage after the
pressure reducer. A mist oiler gives off fine drops of oil into
the air flow and thus guarantees regular lubrication.
–
Manual lubrication
If you do not have a mist oiler, lubricate the tool before
every use or longer work sessions. Add 3–5 drops of
pneumatic oil into the connector nipple
PDSS 16 A1
.
around all threaded connec-
with the supplied
into the air inlet
GB │ IE
.
.
│
45 ■