Placing An Insert Inside An Open Fireplace - Jøtul I 520 Handbuch

Fig. 25
4. Lift the insulation sheet (A) up.
Fig. 26
A
A
5. Use the Allen key supplied to adjust the levelling screws (A)
until the burn chamber is level and at the correct height.
6. Refit the exhaust deflector, the baffle and the side panels.

Placing an insert inside an open fireplace

Fig. 30
A
1. Cut along the knock-out holes at the top of the heat shield
and remove that section.
Fig. 31
A
A
Fig. 32
2. Before inserting the burn chamber inside the fireplace,
remove the log retainer, side burn plates, back burn plate,
baffle and exhaust deflector. These are fitted back into place
when the flue pipe and smoke bell have been installed. See
the figures below.
ENGLISH
25