Connection To Chimney - Jøtul I 520 Handbuch

ENGLISH
rear. Secure it in place using the same screws.
Fig. 4-b
• Pull out the primary air valve handle
• Place the distance clip to the shaft, as shown on (fig. 4-b) to
keep the valve in open position (UK only).
Fig. 4-c
12
1
2
Installation of leg rack (optional)
If building a brick surround, the leg base (optional, item no.
51044759) must be used. See Fig. 1 e and f.
Door hinges
The door is left-hinged as standard but can be changed to right-
hinged if required. If so, it should be changed before placing the
stove inside the hearth or surround.
An optional kit is required to change the door hinging.
Item no. 50045754. (See the manual, item no. 10045851, which
comes with the assembly kit.)

4.8 Connection to chimney

Before installing the product, you need to decide how it is to be
connected to the chimney.
Installation of the smoke bell
The smoke bell can be installed from the outside and the inside.
It is factory-fitted on the outside for a top outlet, but can be
mounted to a top outlet from the inside. It can also be rotated
45° (rear outlet) for installation from both outside and inside.
If installing from the inside, the burn plates, baffle and exhaust
deflector must be removed.