Siemens SINUMERIK 810D series Handbuch Seite 236

12 Komponente PCU 50
12.6 Systeminformationen
IRQ10
IRQ11
PCI IRQ Line 1
PCI IRQ Line 2
PCI IRQ Line 3 / 4 *)
Installed O/S
Reset Configuration Data
Floppy disk controller
Local Bus IDE adaptor
Large Disk Access Mode
Hard Disk Pre–Delay
Memory Gap at 15 Mbyte
Video Adapter Settings
Frame Buffer Size
AGP Rate
Default Primary Video Adaptor
Security
Supervisor Password Is
User Password Is
Set Supervisor Password
Set User Password
Password on boot
Fixed disk boot sector
Diskette Access
Power
APM
Power Savings
Standby Timeout
Hard Disk Timeout
Boot Sequence
IBA 4.0 (Intel Boot Agent)
*) BIOS–Zeilen " PCI Device Slot 3 / Slot 4" und "PCI IRQ Line 3 / Line 4":
12-236
Menü / Parameter
– vorhanden nur bei PCU 70 und PCU 50
– relevant nur bei PCU 70
SINUMERIK 840D/840Di/810D Bedienkomponenten–Handbuch (BH) – Ausgabe 11.02
PCU 50 v 500 MHz
PCU 50 > 500 MHz
und PCU 70
Available
Reserved
5
Auto Select
Auto Select
Other
No
Enabled
Primary
& Secondary
DOS
Disabled
Disabled
–––
–––
–––
Disabled
Disabled
[Enter]
[Enter]
Disabled
Normal
Supervisor
Enabled
Disabled
off
Disabled
Hard Drive
Removable Devices
CD–ROM Drive
––– 22 Slot 0048
v 500 MHz
;
 Siemens AG 2002 All Rights Reserved
11.02
10.00
–
Both
–––
–––
8 MB
2 x
AGP