Output Function; Function Display - Siemens Milltronics Pointek ULS200 Kurzanleitung

Output Function

The alarms can be set to function in the desired mode.
Function
1 *
2
3
4
5
6
7
8
9
10
11
12
13
14
* Factory setting

Function display:

high alarm
high-high alarm
low alarm
low-low alarm
loss of echo alarm
pump up control
pump down control
Setpoints
The setpoints can be set where reference levels,
either from the material in the vessel or from a
target, cannot be provided. This method can also
be used to trim the output levels obtained by the
Reference Method (Quick Start).
The setpoints are referenced from the face of the
sensor. They should not be set at or above the
blanking value, or at or below the range limit.
Factory Setting: Relay 1 = 0.5 m (1.64 ft)
Relay 2 = 4.50 m (14.76 ft)
Page EN-14
Relay 1
high alarm
high alarm
low alarm
high alarm
low alarm
pump down
pump down
pump up
pump up
pump down
pump up
pump down
pump down
pump up
H 
HH 
L 
high-high
LL 
high
LOE 
PU
PD
low
low-low
setpoint
Pointek ULS200 – QUICK START MANUAL
Relay 2
low alarm
high alarm
low alarm
LOE alarm
LOE alarm
low alarm
high alarm
low alarm
high alarm
LOE alarm
LOE alarm
pump up
pump down
pump up
ULS200
blanking
range
limit
7ML19981XB83