Troubleshooting - Scheppach Therbio Originalbetriebsanleitung

Maintenance
Decalcification
Depending on the level of hardness of the water in your
region, over time, there will be calcification on the base
and the inside of the stainless steel container. The hard-
er the water, the faster calcification builds up. It is harm-
less but can compromise the machine's performance.
We therefore recommend decalcification as follows:
• Fill to three quarters capacity with water.
• Heat it up.
• After the machine has turned off, add household
vinegar to the machine (see Fig. 4).
• Note: Do not heat up this mixture.
• Leave the mixture over night.
• Empty the machine and rinse it with clear water sev-
eral times.
Note: You can also use other suitable descaling agents.
Please follow the manufacturer's instructions.
Battery replacement (Fig. 9)
• Remove all the water from the machine.
• Ensure that the machine is turned off and discon-
nected from the mains.
• Remove the screw (a) with a screwdriver (not in-
cluded).
• Remove the battery cover (24) as shown in Fig. 9.
• Disconnect the battery (23) from the plug connection
and remove it.
• Only ever use original spare parts.
• Replace the new battery in reverse order.

Troubleshooting

Problem
Significant pressure fluc-
tuatio
Machine does not work
No pressure
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58  www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58  www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Possible cause
Nozzle blocked
Battery faulty or not charged
On-/off-switch (14) is off
Damaged mains cable
Faulty voltage supply
No water in the tank
Battery faulty or not charged
Nozzle blocked
Storage
• Remove all the water from the machine.
• The weed killer (1) and the accessories will be
destroyed by frost if the water is not removed com-
pletely.
• Store the machine and its accessories in a dark, dry
and frost-free place, inaccessible to children. The
ideal storage temperature is between 5 and 30˚C.
• Store the machine in its original packaging.
• Cover the power tool to protect it from dust and
humidity.
• Keep the operating manual with the power tool.
Solution
Rinse the nozzle (10) with water. If required, clean the noz-
zle with a needle
Change the battery or charge it
Check the on-/off-switch.
Turn the machine off and disconnect it from the mains.
Check the mains connection cable for damage. If required,
have the mains connection cable replaced by an author-
ised specialist.
Check the electrical equipment for compliance with the
information on the rating plate.
Refill with water
Change the battery or charge it
Rinse the nozzle (10) with water. If required, clean the noz-
zle with a needle
19 І 36