Assembly - Parkside PTBM 500 E5 Originalbetriebsanleitung

GB IE
place the battery in direct sunlight and
do not use or store it in motor vehicles
in hot weather.
• Store used batteries in the original pa-
ckaging and keep them away from me-
tal objects. Do not mix (up) unpacked
batteries! Otherwise this may cause the
battery to short-circuit, resulting in da-
mage, burns or even the danger of ire.
• Remove batteries from the device if this
is not going to be used for a prolonged
period, unless it is to be used in emer-
gencies!
• NEVER touch batteries which have
leaked without appropriate protection.
If the leaked liquid comes into contact
with the skin, you should rinse off this
area of the skin immediately under run-
ning water. Make sure at all events that
your eyes and mouth do not come into
contact with the liquid. If they do, seek
medical advice immediately.
• Clean the battery contacts and the
equivalent contacts in the device before
inserting the batteries.

Assembly

The bench drill is supplied disassembled.
Clean the column tube (14), baseplate (17),
drilling bench (20), vice (23) and the drill
chuck (4) beforehand, with a dry cloth.
1. Place the column tube (14) on the ba-
seplate (17). Bolt the column tube (14)
to the baseplate (17) with the three as-
sembly srews (16) supplied. Tighten the
assembly srews (16) moderately tight
so that the threads in the baseplate (17)
do not strip.
2. Place the drilling bench (20) on the co-
lumn tube (14). Push the drilling bench
(20) into a lower position. Use the
30
locking handle (15) to ix the drilling
bench (20) in a lower position.
3. Place the vice (23) on the drilling
B
bench (20). Screw it irmly onto
the drilling bench (20) by means
of the enclosed assembly screws
(22) together with the washer
and the lock washer in the order
as shown.
4. Place the motor unit (13) on
C
the column tube (14). Secure
the motor unit (13) with the two
clamping screws (27) on the
side using the enclosed Allen key
(25).
5. Bolt the three drill lifting arms
into the spindle guide (9). Tigh-
ten the three hole lifting arms
with a spanner (AF 6 mm).
6. Release the
the depth stop (8).
7. Mount the laser on the motor unit
(13) using the ixing screw (41).
Make sure that the battery com-
partment (36) is on the side of
the hand spindle guide (9).
8. Put the safety device (6) on the
upper part of the drill spindle
(7).
9. Secure the safety device (6) with
the clamping screw (28).
10. Fold the safety device (6) up-
wards. Insert the chuck (4) on
the taper of the drill spindle (7).
Push the drill chuck onto the drill
chuck tip with a few light taps.
Use a plastic hammer for this
purpose.
clamping screw from