Residual Risks; Assembly; Setting Up; Mount The Sharpener - Parkside PSS 65 B1 Originalbetriebsanleitung

cohol or tablets, do not work with the
device. Always have a break on time.
• Switch the device off and remove the
mains plug
- to loosen a blocked insertion tool,
- if the connection line is damaged or
entangled,
- in case of unusual sounds.

Residual risks

Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this elec-
tric tool may present the following hazards:
a) Lung damage, if suitable respiratory
protection is not worn.
b) Hearing damage, if suitable ear protec-
tion is not worn.
c) Damages to health due to
- touching the area of the grinding tool
which was not covered;
- the ejection of pieces from workpiece
or damaged grinding wheels.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic fi eld which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and
the manufacturer of their medical
implant before operating the ma-
chine.

Assembly

Caution! Risk of injury!
- Ensure that you have suffi cient
space in which to work, and that
you do not endanger other peo-
ple.
- All covers and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug before
changing the setting on the de-
vice.

Setting up

Place the sharpening station on fi rm sur-
face and fasten the device. Ideally, bolt the
drill to the surface. Use the mounting holes
for the work bench assembly (
baseplate for this.
The screws and nuts required for as-
sembly are not part of the scope of
delivery.

Mount the sharpener

1. Select one of the three sharpeners.
2. In order to remove a sharpener from
the working position, you must press
down the release lever for the sharp-
ener ( 13).
3. Remove the sharpener from the guide
rails, upwards.
4. In the storage positions, the sharpeners
are not fi xed to the right and left side
and can be easily removed from the
guide rails.
5. In order to fasten the selected sharpen-
er in the working position, from above
push this into the guide rails. Press
the sharpener down until it snaps into
place.
GB MT
9) in the
55