Parkside PLV 1500 A1 Originalbetriebsanleitung Seite 24

GB IE
ensures that the equipment re-
mains safe.
• Before starting the equipment, en-
sure that no objects or branches
are pushed into the blade open-
ing, that the equipment is stand-
ing stably and that the work-
space is tidy and not blocked.
Check the condition of your ex-
tension cable and the connecting
cable of your equipment. Use the
necessary protective equipment.
There is a risk of injury.
• If your equipment vibrates or emits
unusual noises when switched
on, disconnect the plug from
the socket and check the cutting
cylinder. Ensure that no remains
of chopped matter are blocking
the cutting cylinder or jammed
between the blades. If you ind no
problems, return the equipment to
a customer service centre.
• If the blades no longer cut cor-
rectly or if the motor is over-
loaded, check all the parts of
your equipment and replace the
worn parts. If a more extensive
repair is required, contact a cus-
tomer service centre.
Use:
• CAUTION – A very sharp tool.
Avoid cutting your ingers or
toes. While working always
keep your feet and ingers well
away from the cutting cylinder
and the ejector opening. There
is the danger of serious injury!
• Do not operate the implement
while it is raining, in poor weather
conditions and when the surround-
ing area and lawn are wet. Op-
erate the implement only during
24
daylight hours or with bright light-
ing. There is a risk of accidents.
• Do not operate the implement if
you are tired or are lacking in
concentration and after having
drunk alcohol or taken medi-
cine. Always take a work break
in due time. Approach the work
with common sense. A moment
of carelessness when using the
equipment can result in serious
injury.
• Familiarize yourself with the
terrain and remain focused on
the potential hazards that you
could miss on account of the
motor noise.
• Always maintain a secure foot-
ing while working, especially
on a sloping terrain. Always
work across slopes - never up
and down! Be particularly care-
ful when changing the travelling
direction. Do not work on very
steep slopes. This enables you
to control the equipment better
in unexpected situations.
• Avoid an abnormal body posture.
• Always guide the implement at
a walking pace with both hands
on the handle. Be especially
careful when you turn the imple-
ment around or draw it towards
you. Danger of stumbling!
• Start or actuate the starting lever
with care and in conformity with
the directions in these Instructions.
• Do not tilt the implement when
starting, other than it has to be
lifted. In this case tilt the imple-
ment only to the extent that is ab-
solutely necessary and always
lift the implement on the side that
is opposite to the operator.