Direction Switch; Bit Selection From The Bit Changeable Drum; Bit Change In The Bit Changeable Drum; Use Extension Bit Holder - Parkside RAPIDFIRE 2.0 Originalbetriebsanleitung

GB IE NI
The LED lamp can continue to be used by
activating the switch block. To do so, press
the on/off switch.

Direction switch

You can toggle between right (
) rotation by pushing the direction of ro-
(
tation switch ( 8).
If you move the direction switch (
the middle position, the device is secured
against being switched on.
The direction changed may
only be performed in stand-
still mode!
Bit selection from the
bit changeable drum
1. Push the slide of the interchan-
geable cordless screwdriver (4)
forward.
2. Turn the bit changeable drum
(14) to the left or right until the
desired bit is located on top and
is in line with the bit holder (3).
The bit changeable drum enga-
ges audibly.
3. Push the slide of the interchan-
geable cordless screwdriver (4)
to the back.
Only grab the side of the
slide of the interchangeable
cordless screwdriver.
Caution, risk of injury caused
by pinching!
The selected bit is automatically fixed in
the bit holder ( 3).
12
CY
) and left
8) to
Bit change in the
bit changeable drum
Remove the bit (
bit holder ( 3).
Insert a suitable 6-point bit in the bit holder
( 3). Because of the 6-point bit holder, it
may be that you need to rotate the bit slight-
ly. Slide the bit right into the bit holder
( 3). The bit is held firmly by the duct and
the magnetic holder.

Use extension bit holder

Remove the current bit (
holder ( 3).
Insert the extension bit holder (
bit holder ( 3). It may be that you need to
rotate the extension bit holder (
because of the 6-point bit holder. Complete-
ly insert the extension bit holder (
the bit holder ( 3). The extension bit holder
( 12) is held firmly by the duct and the ma-
gnetic holder.
To remove the extension bit holder (
simply remove the extension bit holder from
the bit holder ( 3).
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
2) from the
2) from the bit
12) into the
12) slightly
12) into
12),