Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Converting the joysticks
Converting the joysticks
1.
Loosen the four screws holding each of the two
joysticks
2.
Then disconnect the 7 pin plug connector from the
joysticks to the circuit boards.
3.
The joystick circuit boards can now be exchanged.
4.
Reconnect each of the 7 pin plugs to the circuit
board
5.
Reassembly is done in reverse order
Ensure that the axis of the joystick circuit board is proper-
ly positioned in the base.
38
Operating notices
2.
3.
Important notices:
When closing the transmitter housing, ensure that ...
•
... no cables are caught between housing edges
when the backplate is put into position
•
... both housing parts are properly aligned with each
another before screwing them together never force
the housing sections together
•
... screws are tightened carefully to avoid stripping the
existing threads in the housing
•
the transmitter battery is finally reconnected
1.
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
