Speed Controller; Controller Technical Specifications; Commissioning Of The Controller; Programming The Controller Through The Gas Stick - GRAUPNER 13400 Anleitung

Speed controller

Controller technical specifications

Weight with cables
Brake
Continuous current at 25°C
Peak current for 10 sec.
Cell count LiPo, Lilo:
Operating voltage
Dimensions
BEC receiver output:
Servos operating voltage
Servos max.
Controller
Max. RPM 2 Pole
Max. RPM 6 Pole
Max. RPM 12 Pole
Automatic under-voltage cut-off
Automatic overheating cut-off
Automatic motor stop if signal lost

Commissioning of the controller

Note:
The controller can be operated with different transmitters from different manufacturers, to ensure the
optimal operation it is necessary to set the controller to your transmitter.

Programming the controller through the gas stick

1. Move the throttle stick to the full throttle position and connect the battery, the motor plays a melody like "Do Re Mi".
2. After 2 sec. the motor emits 2 long beeps (B-- B--) then the controller has detected the full throttle position. Move
within the next 2 sec. the throttle stick to the stop position, after the tones (B-- B--) the controller detects the stop
position.
3. After a long (B--) the setting is complete and the controller is ready to start.

Disabling the brake

1. Move the throttle stick to the full throttle position and connect the battery, the motor plays a melody like "Do Re Mi".
2. After 2 sec. the motor emits 2 long beeps (B-- B--) then the controller is in programming mode. Move within the next
2 sec. the throttle stick to the stop position, after the short tone (B) the controller has detected disabling the brake.
3. After a long (B--) and a short (B) the setting is complete and the controller is ready to start.

Activate the brake

1. Move the throttle stick to the full throttle position and connect the battery, the motor plays a melody like "Do Re Mi".
2. After 2 sec. the motor emits 2 long beeps (B-- B--) then the controller is in programming mode. Wait for the tone
short (B) from the brake disabled then follows the sound with 2 short (BB) activates the brake. Move within the next
2 sec. after the short tone (BB) the throttle stick to the stop position, the controller has detected the activation of the
brake.
3. After a long (B--) and a short (BB) the setting is complete and the controller is ready to start.
2015/02/12
innovation & technology
43 g
programmable
40 A
55 A
2 - 4
7,4 - 16,8 V
65 x 25 x 12 mm
5 V / 4 A
4,8 - 6 V DC
4
40 A
210000 T/min
70000 T/min
35000 T/min
YES
110 °C
YES
EN
13