Installation Step 3 (Control Of Screws); Installation Step 4 (Installation Of The Rc Components) - GRAUPNER Premium Line Nordic Anleitung

Installation Step 3 (Check the screw)
Check the screws on the shaft coupling, the motor mounting bracket and the propeller on a firm seat, as
these might have come loose during transport if necessary. You can check this by pulling on the propeller,
the shaft should be pull out to the rear, is one of the set screws loose. Then pull it back gently laid. IMPORTANT:
Back up any loose set screws with thread lock, eg UHU security screws (Order No. 952), as they
may become loose due to vibration during operation. The grub screws are loosened with the longitudinal slot
screwdriver, hold the shaft with a flat nose pliers firmly to avoid slipping.

Installation Step 4 (installation of the RC components)

Please act according to the wiring diagram. Pay attention to the direction of rotation of the motors when the battery is
connected, the drives should rotate so that the model would move forward.
Install the batteries with velcro in the model. NOTE: The Velcro strap you can change the position of the batteries easy
to achieve the optimal trim. The batteries are typically in block of four right in front of the engines you platziert.Legen
when required ballast in the hull. These elements can be particularly flat sections of steel or lead. Trim the model
and secure the ballast weights with adhesive. TIP: If you attach the allastgewichte with Velcro, you can if necessary
(eg ease of transport) found. TIP: To iederzufinden the correct position of the weights again without re-trimming, you
should mark the location with waterproof crayon. Mount the receiver under the deck and the speed controller left and
right to the hull by means of Velcro.
17