Switch Off; Actuate Pumps Manually - Kessel Aqualift S XL Anleitung Für Einbau, Betrieb Und Wartung

5.4

Switch off

• Disconnect the mains supply, the acoustic alarm sounds and the alarm LED flashes.
• Switch off the acoustic alarm; to do this press button <69> (Fig. [14]) (approx. 1 second) until the alarm symbol
on the display is crossed out.
• Switch off the control unit; to do this keep the button <69> pressed (at least 5 seconds) until the display and the
alarm LED are switched off.
The control unit is switched off, the pumping station is switched off.
Installations without control unit:
• Disconnect the mains plug!
5.5

Actuate pumps manually

Installations with control unit:
• Briefly press the pushbutton of the respective pump <71 or 73, Fig. [13]>; manual mode is switched on
• Briefly press the pushbutton again, the pump runs for approx. 5 seconds. If the pushbutton is pressed for a
longer time, the pump continues running until the button is no longer pressed.
Installations without control unit:
• The pump is started manually by lifting the float.
2017/10
Operation
42 / 148
010-993