Initial Commissioning; Switch On And Off; Carrying Out Initialisation - Kessel Aqualift F 400V Mono Einbau- Und Betriebsanleitung

5

Initial commissioning

5.1

Switch on and off

Connect the battery
Connect the battery connector(s) (2).
Establish mains voltage (400V control units)
Connect the mains cable to the mains power supply.
Move main switch (1) into ON position.
Initialisation starts automatically.
The device checks the electrical components.
Voltage test of the standby batteries.
|3.10. Languagee|
Menu item
Switch on
Move main switch (1) into ON position. After a successful
system test, the display shows
the green LED signals readiness.
If the display does not show initialisation (
guage|
) the control unit has already been initialised. In
this case, the set parameters must be checked, or reset to
|3.11 Reset|
the factory settings (
the factory settings, the initialisation of the control unit starts
automatically.
Please note that the counter for the maintenance interval is
not changed by the reset to the factory settings.
5.2

Carrying out initialisation

During initialisation, the following input is expected:
|Language|
|Date / Time|
|Product type|
|System variant|
|Power rating|
|S1 / S3 operation|
|Maintenance interval|
Language
► Press OK.
► Use the cursor keys to select the language and confirm with OK.
|Date / Time|
Menu
Date / Time
► Set the respective flashing figure in date and time and confirm with OK.
|Product type|
Menu
Product type
► Select product type and confirm with OK.
Selection affects which setting options are available.
|System variant|
Menu
System variant
► Select the system variant. The system variants can be found in the respective manufacturer's documents.
Selection affects which setting options are available.
|Power rating|
Menu
Power rating
Selection of the power rating. Pump power is noted on the pump's type plate.
|S1 / S3 operation|
Menu
36 / 136
is displayed.
|0 System info|
and
|3.10. Lan-
). After resetting to
appears.
appears.
appears.
appears.
appears.
Installation and operating manual
2
1
010-532