Error Codes - IKA C-MAG HS 7 control Betriebsanleitung

› H 135.104 block 4 × 20 ml
› H 135.105 block 4 × 30 ml
› H 135.106 block 4 × 40 ml
› H 135.107 block 100 ml
› H 135.108 block 250 ml
Flask carrier
› H 135.20 flask carrier 100 ml without handle
› H 135.21 flask carrier 100 ml with handle
› H 135.25 flask carrier 250 ml without handle
› H 135.26 flask carrier 250 ml with handle
› H 135.30 flask carrier 500 ml without handle
› H 135.31 flask carrier 500 ml with handle
› H 135.40 flask carrier 1,000 ml without handle
› H 135.41 flask carrier 1,000 ml with handle
› H 135.50 flask carrier 2,000 ml without handle
› H 135.51 flask carrier 2,000 ml with handle
Flask inlay
› H 135.201 flask inlay 10 ml
› H 135.202 flask inlay 25 ml
› H 135.203 flask inlay 50 ml
› H 135.301 flask inlay 100 ml
› H 135.302 flask inlay 250 ml
› H 135.401 flask inlay 500 ml
› H 135.501 flask inlay 1,000 ml
General accessories
› Heating block adapter for C-MAG
› H 16 V support rod
› H 16.3 extension
› H 38 holding rod
› H 44 boss head clamp
› PT 1000 series temperature sensor
› ETS-D5 electronic contact thermometer
› ETS-D6 electronic contact thermometer
For further accessories see www.ika.com.
104 Accessories

Error codes

/// Troubleshooting correctly
The stirrer displays an error code; following is an overview
of possible errors and solutions.
Proceed as follows in such cases:
› Turn off the device by using the power button.
› Carry out corrective measures.
› Restart the device.
Error code | Causes | Effect | Solutions
Err. 1 – Watchdog error 1
› PC does not transmit any data within
the set watchdog time
Causes › connection to PC interrupted
› heating switched off
Effect
› motor switched off
› change watchdog time
› transmit data from PC within set
Solutions
watchdog time (OUT_WDx@m)
› check cable and plug
Err. 2 – Watchdog error 2
› PC does not transmit any data within
the set watchdog time
Causes › connection to PC interrupted
› heating switched off
Effect
› motor switched off
› change watchdog time
› transmit data from PC within set
Solutions
watchdog time (OUT_WDx@m)
› check cable and plug
Error codes 105