Start Up; Operation; Connecting An External Thermometer - IKA C-MAG HS 7 control Betriebsanleitung

Start-up

/// Operation

Remove the protective film from the plate before using device!
Power-up
Press the power button (A) to the right.
1.
Insert the power cord into the power outlet (J).
2.
Press the power button (A) to the left.
3.
› Standard mode A is selected.
Stirring
Set the speed using the rotating knob (D).
1.
› The set speed value (01) is shown on the display (H).
Press the rotating knob (D) to start the stirring function.
2.
Heating
Set the safety temperature limit (11).
1.
Set the target temperature using the rotating knob (C).
2.
› The set temperature value (02) is shown on the display (H).
Set the temperature control mode (09).
3.
Press the rotating knob (C) to start the heating function.
4.
General heating information
› The target and current temperature (02, 07)
are shown permanently on the display (H).
› When the heating function is switched on,
the heater activated symbol (06) is displayed.
› When the device is switched off while the heating plate temperature
is higher than + 50 °C, the display (H) shows HOT! and the current
temperature (07) is shown, even if the device is switched off.
76 Start-up

Connecting an external thermometer

Press the power button (A) to the right.
1.
Connect the safety contact thermometer compliant with
2.
DIN 12878 Class 2 or temperature sensor PT 1000
(individual sensor) to the connection (M).
Press the power button (A) to the left.
3.
Temperature sensor PT 1000
› The actual temperature (07) shown on the display (H)
corresponds to the temperature of the medium.
The symbol (13) is shown on the display.
Contact thermometer ETS-D5 / ETS-D6
› Follow the instructions for the contact thermometer.
The actual temperature (07) is shown on the display (H).
The symbol (14) is shown on the display.
Menu
Press the "Menu" key (E) for to enter the menu mode.
1.
Set the menu items by turning the rotating knob (D) and
2.
confirm by pushing it.
Press the "Menu" key (E) to enter the menu only possible
3.
if stirring and heating is switched off.
Press the "Menu" key (E) to exit the menu from each state
4.
of the Settings menu.
Start-up 77