Regulations - IKA C-MAG HS 7 control Betriebsanleitung

Err. 25 – Heating switching element monitoring fail
Causes
Effect
Solutions
Err. 26 – Plate temperature > plate safety temperature (more than + 40 K)
Causes
Effect
Solutions
Err. 31 – Fault in the heater switch element
Effect
Solutions
Err. 44 – Heating plate safety temperature is higher
than the set safety temperature
Causes
Effect
Solutions
108 Error codes
› heater control circuit switch (TRIAC) short-circuited
› safety relay has interrupted the heating circuit
› heater or the supply line is disconnected
› disconnection of heating plate safety temperature sensor
› heating switched off
› switch device off, leave to cool and switch on again
› irregular temperature distribution across heating plate
due to sporadic heat dissipation
› defective control or safety temperature sensor
› heating switched off
› switch device off, leave to cool and switch on again
› ensure regular heat dissipation when using metal blocks,
etc. on the flat surface of the heating plate
› heating switched off
› contact customer service
› SAFE TEMP H (Hotplate) has been set to lower than the
safety temperature of the heating plate
› disconnection of heating plate safety temperature sensor
› heating switched off
› leave the heating plate to cool
› set the SAFE TEMP H (Hotplate) higher
Err. 46 – Plate safety temperature > plate temperature (more than + 40 K)
› irregular temperature distribution across heating plate
due to sporadic heat dissipation
Causes › defective control or safety temperature sensor
Effect › heating switched off
› switch device off, leave to cool and switch on again
Solutions › ensure regular heat dissipation when using metal blocks,
etc. on the flat surface of the heating plate
If the actions described fails to resolve the fault or another error
code is displayed then take one of the following steps:
› contact the service department.
› send the device for repair, including a short description of the fault.
Warranty

/// Regulations

In accordance with IKA warranty conditions, the warranty period is 24
months. Upon registering this device at www.ika.com/register, your product
will be subject to a lifetime warranty. For claims under warranty, please cont-
act your local dealer.
The warranty does not cover worn out parts, nor does it apply to faults
resulting from improper use, insufficient care or maintenance not carried
out in accordance with the instructions in this operating manual.
Error codes | Warranty 109