Operation - pyrexx RWM MC Betriebsanleitung

5 Operation

5.1 Switch on the RWM MC
Switch on the RWM MC as follows:
f Press and hold the Start button for
3 seconds.
Two signal tones
5 Homescreen is displayed:
5 Type, version number, manufacturer,
and year of manufacture of the
RWM MC are shown:
EN
Operating Manual: RWM MC - Diagnostic device for smoke alarm devices
EN
5 Message"Initialisiere Auslesesoft-
ware"(Initiate readout software) is
displayed:
5 The device is switched on and is in
stand-by mode.
5.2 Connect the RWM MC to the
smoke alarm device
Reading out of the smoke alarm device
first requires a connection between the
RWM MC and the smoke alarm device.
Establish the connection as follows:
(1) Remove the Testing / stop button
(smoke alarm device cover).
f Observe the operating manual for
the smoke alarm device.
33