inshape 17170 Gebrauchsanweisung Seite 48

Assembly
Step 1
Place the rail (3) and seat (36) with the
underside facing upwards.
Push the seat over the rail. Screw the stop
plate (35) securely to the rail using 2 screws
(67).
Screw the rear stabiliser (4) securely to the
rail using 4 washers (71) and 4 nuts (66).
Tighten the nuts using the multi-key (75).
Step 2
Screw the two caps (25, 26) securely to the
front stabiliser (2) using 2 screws (68) with
the help of the multi-key.
48
Step 3
Raise the frame (1) up. Screw the front
stabiliser securely to the frame using 8
washers (71) and 8 screws (60). Insert screws
into 3-4 of the screw holes � rst and tighten
them by hand. Insert the remaining screws
and tighten them by hand.
Finally, tighten all the screws using the Allen
key (74).