Preparing The Holes On The Machine; Fitting The Unit On The Bracket; Electric Hook-Up - Olimpia splendid UNICO AIR Handbuch Für Installation, Gebrauch Und Wartung

couple the t o chains to the large e elet of the spring.
- Using one hand grip the t o chains connected to the grid.
- Bend the external grids back gripping them ith our free hand here the bend and insert our ngers inside the single
ns ( g. 13).
- Insert our arm into the pipe until the grid protrudes completel out ards.
- Reopen the grid being careful to keep our ngers inside the ns.
- Turn the grid until the ns are full horizontal and tilted do n ards.
- Pull the chain tensioning the spring and couple the chain ring to the pin of the inner ange through hich the pipes pass ( g.
14).
- Use hand shears to cut off an excess chain links.
WARNING: use exclusively the supplied grids, or grids with like characteristics.
2.3.5

Preparing the holes on the machine

The unit as built to be paired ith 162-mm.
2.3.6

Fitting the unit on the bracket

After having checked that the xing bracket is properl anchored to the all and that the suitable preparator
has been carried out for the electrical connections and the condensate drainage the air-conditioner can be xed to the all. Lift it
b holding it from the sides of the lo er base (see g. 15).
To facilitate the operation of fastening it to the bracket tilt it slightl to ard ou.
To make the electrical connection and fasten the drainpipe place a edge bet een the air conditioner and the all (see g. 15).
When ou have nished inspect carefull to make sure there are no ssures at the back of the air conditioner (the insulating gasket
must t rml against the all) particularl in the zone here air enters and leaves the machine.
2.3.7

Electric hook-up

The appliance is tted ith a po er cord ith plug (Y-t pe connection). If the socket is in proximit to the appliance simpl plug it in.
Before connecting the conditioner ensure that:
- The po er suppl voltage and frequenc values compl
- The po er suppl line is tted ith an ef cient earth connection that is appropriatel sized for the maximum absorption
of the conditioner (minimum cross-section of the cable must be 1.5 mm
- The appliance is po ered exclusivel through a socket that is compatible ith the plug supplied.
WARNING: Any replacement of the power cable must be carried out solely by Olimpia Splendid technical support or by
WARNING: On the power supply line of the appliance there must be an adequate omnipolar disconnection device that
complies with the national installation regulations. It is, however, necessary to check that the electrical power supply is
delayed fuse or other devices with equivalent functions are recommended).
ith those indicated on the data plate of the appliance.
).
2
2
ork - if required -
31
UNICO AIR