Cleaning; A - Cleaning The Appliance And The Remote Control; B - Cleaning The Suction Filter; C - Recommendations For Energy Saving - Olimpia splendid DOLCECLIMA BREZZA Gebrauchs - Und Wartungsanweisungen

4.1 - CLEANING

4.1.a - Cleaning the appliance and the remote control

a. Use a dry cloth to clean the appliance and the remote control.
b. It is possible to use a cloth moistened with cold water to clean the appliance in case it's very dirty.
Do not use a chemically treated or antistatic cloth to clean the appliance.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic surface.
4.1.b - Cleaning the suction filter
To ensure the indoor air is filtered correctly and to guarantee that your air conditioner runs efficiently, it is
vital to clean the air filters regularly.
A dirty air filter reduces the cooling capacity of the appliance. Please clean the filter once every 2
weeks.
a. Release the grille (27) together with the filter (27a) and raise it to remove it from the appliance (Fig.15).
b. Remove the filter (27a) from the grille (27) (Fig.16).
c. Clean the filter (27a) using a vacuum cleaner or wash it with water, then let it dry in a fresh environment.
d. Suck possible fluff from the plates (Fig. 17).
Provide for the filter (27a) replacement if it is damaged.
e. Make sure the filter (27a) has dried completely.
f. Reposition the filter (27a) in the grille (27) paying attention to its correct positioning.
g. Position the grille (27) together with the filter (27a) on the appliance body making sure it is correctly hooked
(Fig.18).
Do not use the appliance without the filter (27a).

4.1.c - Recommendations for energy saving

Below find simple recommendations for reducing consumption:
• Always and constantly keep the filters clean (see maintenance and cleaning chapter).
• Keep the doors and windows of the rooms to be climate controlled closed.
• Do not let sun rays penetrate freely into the room (we recommend using curtains or lowering blinds or
closing the shutters).
• Do not obstruct the air flow path (input and output) of the appliance; this, in addition to obtaining a non-op-
timal yield, also affects the correct operation of the appliance and the possibility of irreparable damages to
the appliance itself.

4.2 - MAINTENANCE

If you do not intend to use the appliance for a long period of time, work as follows:
a. Activate the fan only mode for a few hours (approximately 1÷2 hours) to dry the interior of the appliance.
b. Stop the air conditioner and disconnect the power supply.
c. Clean the air filter.
d. Completely discharge condensation.
e. Wrap the power supply cable (34) around the cable winder (33) and insert the plug in the specific housing
(31) (Fig.21).
f. Remove the batteries from the remote control.
g. Place the appliance in its original packaging and store it in a fresh and dry environment, away from direct
exposure to sunlight.
EN - 18