Use And Maintenance - Baron SERIE 700 Aufstellung, Gebrauchs- Und Instandhaltungs Anweisungen

Data Emissione 17/09/2004
- Extract the knob and remove the screws fastening the switch-
thermostat unit onto the control board.
- The switch and the thermostat are axially assembled through the
insertion of a proper connection flange: remove this flange to
release the two components.
- Replace the component and reassemble carrying out the same
operations backwards.

6 - USE AND MAINTENANCE

6.1 Warning
This equipment must exclusively be used for the aim it has been
designed for, that is, to cook food. Consequently any other use is
improper.
This equipment has been conceived for industrial use, therefore it
must be operated exclusively by trained personnel.
Its installation and possible transformation for other supply voltages
(when possible) must be carried out only by authorized and qualified
installers.
In case of troubles, disconnect the main power switch, installed
before the equipment.
For any repair, call the authorized After-Sales Service and require
only original spare parts.
Not complying with these instructions may seriously
compromise the safety of this equipment; the manufacturer
declines any liability in case these warnings are not complied
with
6.1.1 Use
Do not use the cook top of pyroceram as support for pots and
vessels.
Do not leave any vessel (especially of plastic or aluminium) on the
top of pyroceram, because they can melt when heated.
When using the top of pyroceram, check that the bottom of pots and
pans, as well as the cooking area are dry and clean.
Rubbing the bottom of pots and pans on the plate of pyroceram can
wear its surface.
Do not use the top of pyroceram to cut vegetables, or similar
foodstuff.
If possible. use pots and pans with bottoms wider than the cooking
area, to avoid accidental spills on pyroceram surface.
In detail, sugary solutions can provoke serious damages.
Before using the cook top, clean all the surfaces in contact with
food, carefully.
6.2 Use of the cook top (fig. 1 - fig. 1/A)
Cook tops are provided with 2 or 4 radiating plates, according to
models; each plate is controlled by a supply controller of various
positions.
Start heating any plate turning its respective control knob M: this will
be signalled by the warning light H1 (figs. 1 and 1/A).
Radiating plates with a single power stage: from 1.2 to 1.8 kW
(fig. 1 - fig. 1/A)
The control knob is marked with the following symbols:
0 Plates off
Plates heated with the minimum power:
1 approximately 10%
2-8 Intermediate power values of
plates: 20% to 60%
9 Plates heated with the maximum power
Radiating plates with 2 power stages: 2.4 and 3.4 kW
Turning the knobs from 1 to 9 controls exclusively the heating
of the central branch of the plate:
0 Plates off
Central branch of the plate heated with
1 minimum power: approximately 10%
2-8 Intermediate power values of the central
branch of the plate: 20% to 60%
Central branch of the plates heated with
9 the maximum power
Enable the external heating branch of 2-stage plates turning
the knob in clockwise direction beyond the position 9, to the
stop (overcoming the action of a return spring).
When released, the knob returns to the position 9.
Connecting the external branch
Disconnect the external heating branch turning the knob to 9 in
anticlockwise direction.
Disconnecting the external branch
6.3 Use of the electric oven (fig. 3)
Safety devices
The oven is equipped with a safety three-pole thermostat of manual
reset. When the cooking compartment is overheated, this element is
enabled and disconnects the power supply from the heating
resistors. The yellow LED is off, whereas the green one is kept on.
In this case, disconnect the equipment turning the knobs MT and
ME to 0, cut off the power supply turning off the main switch,
installed before the equipment, and call the after-sales service.
This oven is equipped with 2 control knobs and 2 LEDs - warning
lights (fig. 1/B):
- Knob of the main switch / thermostat MT, for controlling the
cooking temperature
- Knob of the power controller ME, for controlling the power sent to
the top resistors of the cooking compartment
17
Revisione 0.0