Activating The Rinse Aid Dispenser; Technical Data - Electrolux ESL 46510 Benutzerinformation

Problem
Limescale particles on the
dishes.
There are streaks, whitish
stains, or a bluish layer on
glasses and dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and matt.

Activating the rinse aid dispenser

1. Activate the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold buttons (4) and (5) at the
same time until the indicators of buttons
(3), (4) and (5) flash.
4. Release buttons (4) and (5).
5. Press button (4).
• The indicators of buttons (3) and (5)
go off

TECHNICAL DATA

Dimensions
Water supply pressure
Possible cause
The spray arms could not turn
freely. Incorrect position of the
items in the baskets.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect level of the water soft-
ener adjustment.
The salt container cap is not
closed correctly.
The rinse aid quantity is too
high.
The rinse aid quantity is too
low.
The detergent can be the
cause.
The washing programme was
without a drying phase or with
a decreased drying phase.
The rinse aid dispenser is emp-
ty.
The multitab function is on (this
function automatically deacti-
vates the rinse aid dispenser).
6. Press button (4) to change the setting.
7. Deactivate the appliance to confirm.
Width
Height
Depth
Minimum
Maximum
Possible solution
Make sure that an incorrect po-
sition of the items do not cause
the blockage of the spray arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener with
the correct level.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid quantity.
Increase the rinse aid quantity.
Use a different brand of deter-
gent.
For better drying results, keep
the door ajar for some minutes.
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispenser.
• The indicator of button (4) continues
to flash
• The display shows the setting of the
rinse aid dispenser.
electrolux 31
Rinse aid dispenser
is off.
Rinse aid dispenser
is on.
446 mm
818 - 898 mm
550 mm
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)