Activating The Rinse Aid Dispenser; Technical Data - Electrolux GA60LI220 Benutzerinformation

16 electrolux
Problem
Limescale particles on the
dishes.
There are streaks, whitish
stains, or a bluish layer on
glasses and dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and matt.

Activating the rinse aid dispenser

1. Activate the appliance. Make sure that
the appliance is in setting mode.
2. Press and hold function button (B) and
function button (C) at the same time un-
til the programme indicators above
function buttons (A), (B), and (C) start to
flash.
3. Release function button (B) and function
button (C).
4. Press function button (B).
• The programme indicators above
function button (A) and function but-
ton (C) go off.

TECHNICAL DATA

Dimensions
Water supply pressure
Possible cause
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect level of the water soft-
ener adjustment.
The salt container cap is not
closed correctly.
The rinse aid quantity is too
high.
The rinse aid quantity is too
low.
The detergent can be the
cause.
The washing programme was
without a drying phase or with
a decreased drying phase.
The rinse aid dispenser is emp-
ty.
The multitab function is on (this
function automatically deacti-
vates the rinse aid dispenser).
5. Press function button (B) to change the
6. Deactivate the appliance to confirm.
Width
Height
Depth
Minimum
Maximum
Possible solution
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener with
the correct level.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid quantity.
Increase the rinse aid quantity.
Use a different brand of deter-
gent.
For better drying results, keep
the door ajar for some minutes.
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispenser.
• The programme indicator above func-
tion button (B) continues to flash.
• The display shows the setting of the
rinse aid dispenser.
setting.
The rinse aid dis-
penser is deactiva-
ted.
The rinse aid dis-
penser is activated.
596 mm
818 - 898 mm
575 mm
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)