Activating The Rinse Aid Dispenser; Technical Data - Electrolux GA60GLI220 Benutzerinformation

Problem
There are streaks, whitish
stains, or a bluish layer on
glasses and dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and matt.

Activating the rinse aid dispenser

1. Activate the appliance. Make sure that
the appliance is in setting mode.
2. Press and hold function button (B) and
function button (C) at the same time un-
til the indicators of function buttons (A),
(B), and (C) start to flash.
3. Release function button (B) and function
button (C).
4. Press function button (B).
• The indicators of function button (A)
and function button (C) go off.

TECHNICAL DATA

Dimensions
Water supply pressure
1)
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
The rating plate on the inner edge of
the appliance door shows the electrical
connection data.
If the hot water comes from alternative
sources of energy, (e.g. solar panels,
Possible cause
Incorrect level of the water soft-
ener adjustment.
The salt container cap is not
closed correctly.
The rinse aid quantity is too
high.
The rinse aid quantity is too
low.
The detergent can be the
cause.
The washing programme was
without a drying phase or with
a decreased drying phase.
The rinse aid dispenser is emp-
ty.
The multitab function is on (this
function automatically deacti-
vates the rinse aid dispenser).
5. Press function button (B) to change the
6. Deactivate the appliance to confirm.
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
Place settings
Possible solution
Adjust the water softener with
the correct level.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid quantity.
Increase the rinse aid quantity.
Use a different brand of deter-
gent.
For better drying results, keep
the door ajar for some minutes.
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispenser.
• The indicator of function button (B)
continues to flash.
• The display shows the setting of the
rinse aid dispenser.
setting.
photovoltaic panels and aeolian), use a
hot water supply to decrease energy
consumption.
electrolux 71
The rinse aid dis-
penser is off.
The rinse aid dis-
penser is on.
596 mm
818 - 898 mm
575 mm
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
maximum 60 °C
12