General Instructions - Casualplay protector FIX Bedienungsanleitung

• Check the different parts of the seat regularly.
• The seat should not be used without its cover.
• Only the cover supplied by the seat manufacturer should be used, as it is an important
part of the product.
• You are responsible for the child's safety.
• The upholstery should be hand washed, using mild soap and warm water; or machine
washed at a maximum temperature of 30º C and WITHOUT SPINNING. Do not use
chemical cleaners (dry-cleaning).

GENERAL INSTRUCTIONS

PROTECTOR FIX Assembly (see illustrations 01 - 04)
• The PROTECTOR FIX arrives disassembled for easier transport (fig. 01)
• Position the back so that the clamp is between the metallic structure of the PROTECTOR
FIX base (fig. 02 - 03), never behind it (fig. 04). A "characteristic click" confirms that the
attachment has been made successfully.
WARNING: Never use PROTECTOR FIX without the back section as it has been
accredited as a unit. Using it without the back section will affect the health of the child.
PROTECTOR FIX Installation inside the car (see illustrations 05 -
12)
• PROTECTOR FIX must be installed in the back seat of the vehicle with a three point seat
belt and the ISOFIX connectors.
• Remove the headrest from the seat where you are going to install the seat (fig. 05).
• Position the clips in front of both ISOFIX slots, which are situated between the seat and
the backrest (fig. 06).
NOTE: If the vehicle came supplied with these connectors, it is not necessary to
assemble them.
•
Next press either the left or right button (fig. 07) and, while keeping it pressed down,
extend the length of the connector bars (fig. 08).
• Put the PROTECTOR FIX in the back seat of the car (fig. 09) in front of the ISOFIX
hooks.
• Push the safety seat with both hands in the direction towards the anchorages until
a "click" tells you that the attachment on both sides has been made (fig. 10).
• Check the correct installation of the system, by verifying that a green line appears on the
upper part of the connector unlocking devices (fig. 11). If a red line appears in one of the
connectors, it indicates that it is not correctly attached. Re-start the operation.
• Finally, adjust the free play between the PROTECTOR FIX and the back of the car by
pressing either of the side buttons on the base, and pushing the safety seat firmly towards
14