Werbung
Verfügbare Sprachen
Verfügbare Sprachen
in car. To tighten the shoulder straps, pull at the end of the belt to the tensor straps
TMS until getting the adjustment wished (A). To slacken the shoulder straps press
the TMS in the B arrow direction and pull the shoulder straps with the other hand.
Then loosen the abdominal belt by pressing the red button of the safety buckle (B).
NOTE: Harness must be reasonably tight, it should restrain but not make child
uncomfortable. Check that no strap is twisted while child is seated. The importance
of ensuring that any lap strap is worn low down, so that the pelvis is firmly engaged,
shall be stressed.
(4D) RECLINE
• The AUTOPLAY seat can easily change position from upright to recline with
only one hand by using the adjustment handle at the front of the seat.
NOTE: Check that seat is not between two positions.A "click" sound will confirm
that child seat is locked in the right position.
(5D) fASTENING BUCKLE
• To close the harness buckle, check shoulder straps are not twisted , joint the two
parts and introduce them into the female part with red button and push until
to hear a "click" sound. To open push the red button.
WASHING INSTRUCTIONS
• Machine wash the cover at a maximum temperature of 30º C and without spinning.
The painted parts should be cleaned using a non-abrasive polish that does not
contain solvents.
fITTING AND REMOVAL Of THE PROTECTORS
• To slacken the harness belts press down the uppr part of the adjuster TMS and
pull out the shoulder belts under the protectors with the other hand (A).
• Remove the metal plates located at the back of the carcasse by pulling them
inwards (B,C).
• Remove the two ends of the harness belt from the junction plate, located in the
back of the carcasse (D).
• Insert the straps ends inside the junction plate.
• Pass the straps of the upper part of the protectors trough the slots and place them
inside the metal plates (fig. C,E).
• To remove the shoulder protectors (fig. f) proceed according to fig. A,B,C,D.
16
Werbung
