General Instructions - Casualplay barra soporte Anwendungshinweise

READ CAREFULLY THESE INSTRUCTIONS BEFORE USING THE
PRODUCT AND KEEP THEM UP FOR FURTHER CONSULTS. IF
THESE INSTRUCTIONS ARE NOT FULFILLED, CHILDREN'S SAFETY
COULD BE AFFECTED.

GENERAL INSTRUCTIONS

Fitting the Support Leg (see illustrations 1-3)
• Once the seat has been fastened onto the vehicle seat using the Isofix
system and its correct installation has been checked (see green line on
the outer side of both of the connector release devices).
• Remove the two stoppers from the front part of the base (fig. 1).
• Simultaneously press the two pivots on the upper tubes.
• Insert both of them into the front slots making sure they go in simultane-
ously to stop them from blocking (fig. 2). When they click they are fas-
tened correctly.
• Pull the red intermediate fastening part outwards with one hand, while,
with the other hand, press the telescopic support of the bar against the
floor of the vehicle. Release this part and check that the tube is not in-
between two locking positions (fig. 3).
• If the tube is in-between two positions, pull the red intermediate fasten-
ing part outwards again and lengthen or shorten the tube to the upper or
lower locking position to obtain the maximum support possible.
Dismantling the Support Leg (see illustrations 4-5)
• Pull the red intermediate fastening part outwards with one hand, while
the other hand folds up the telescopic support (fig. 4).
• Simultaneously press the two buttons on the upper part of the base and
at the same time pull the upper tubes of the Support Leg (fig. 5).
6