Checking The Battery; Measurements - Bosch KTE 001.05 Bedienungsanweisung

3.4

Checking the battery

• KTE 1.05/1.06
Set measurement-mode selector switch to
position "kΩ".
Short-circuit the green and yellow clips.
The instrument pointer must register "0" on
the resistance scale, otherwise the 9 V dry
battery must be replaced.
Repeat this battery check from time to time.
• KTE 1.03/1.07
When the Pocket-Motortester is not
in use, move the selector switch to
the "Aus/Off" position. Otherwise,
the dry battery discharges!
If the dots on the digital display flash in the
following switch positions:
rotational speed (rpm)
dwell angle (% <)
voltage (V),
the battery is used up and must be
replaced.
If the dots flash on the digital display
while the resistance is being mea-
sured, then the resistance is greater
than 100 kΩ!
4.

Measurements

4.1 Rotational speed measure-
ment
4.1.1 Connections
Any work on the ignition system
may only be carried out when the
engine is at a standstill and the
ignition is disconnected (see
also "Information for your
safety", page 17).
• Coil ignition and
• Breaker-triggered or breakerless transis-
torized ignition system
15
456036P
A
yellow clip A: ignition coil, terminal 15
green clip B: ignition coil, terminal 1
1
B
21