HBM P2VA2 Montageanleitung Seite 6

Safety instructions
4
dangers if it is inappropriately installed and operated by
untrained personnel.
Any person instructed to carry out installation, commis­
sioning, maintenance or repair of the device must have
read and understood the Operating Manual and in partic­
ular the technical safety instructions.
Accident prevention
You must make sure that the line is not under pressure
when installing or removing the pressure transducer.
Remaining dangers
The scope of supply and performance of the transducer
covers only a small area of measurement technology. In
addition, equipment planners, installers and operators
should plan, implement and respond to the safety engi­
neering considerations of pressure measurement tech­
nology in such a way as to minimize remaining dangers.
Prevailing regulations must be complied with at all times.
There must be reference to the remaining dangers asso­
ciated with pressure measurement technology.
Although the P2V is designed for maximum safety, safety
engineering regulations demand that burst protection is
implemented around the transducer.
The transducer must be protected against mechanical
loads or knocks.
The resistance of the steel of the measuring body only
applies if temperatures are never allowed to fall below or
rise above the limits specified in the data sheet.
If these temperature limits are exceeded, in the event of
fire, for example, the transducer will be unusable.
A significant change in the zero signal shows that the
device has come to the end of its service life.
A1564-7.0 HBM: public
P2V