Setting The Fan Operating Mode; Activating Single-Sensor Mode; Starting Up - Harvia SENTIO just sauna combi weiß Gebrauchs- Und Montageanleitung

Installation instructions, only for experts

8. Starting up

The function selection switch in the
low-voltage connection area allows
a variety of product functions to be
activated. The figure at the right
shows the standard setting for the
function selection switch.
Note that the control unit needs to
be switched off for 10 seconds after
making changes so that the settings
are saved.

8.1. Setting the fan operating mode

The fan can either be dimmed or switched on and off. The dimmer function
is activated or deactivated using the function selection switch 1.
● The function selection switch 1 is set to the ON position as standard. This ac-
tivates the dimmer function.
● If you wish to deactivate the fan dimmer switch, place the function selection
switch 1 in the OFF position.

8.2. Activating single-sensor mode

In single-sensor mode, the sauna control unit is operated with the heater sensor
with an excess temperature fuse (F1) only. The single-sensor mode must be
activated above the function selection switch 2.
OFF
Fig. 6 Function selection switch –
Standard setting
p. 27/46
EN