General Power Tool Safety Warnings; Work Area Safety - Parkside PHKSA 12 A1 Originalbetriebsanleitung

High-speed battery charger: PLG 12 A2
INPUT:
Rated voltage:
Power consumption:
OUTPUT:
Rated voltage:
Rated current:
Charging time:
Fuse (internal):
Protection class:
Noise emission value:
Noise measurement value determined in accor-
dance with EN 62841 . The A-rated noise level of
the power tool is typically as follows:
Sound pressure level: L
Uncertainty K: K
Sound power level: L
Uncertainty K: K
Wear hearing protection!
Vibration emission value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 62841:
Sawing wood a = 2 .3 m/s
h,W
Uncertainty K = 1 .5 m/s
NOTE
► The vibration emission value and noise
emission levels specified in these instructions
have been measured in accordance with the
standardised testing procedure specified and
can be used to make equipment compari-
sons . The specified vibration emission value
and the noise emission values can also be
used to make an initial load estimate .
PHKSA 12 A1
230–240 V ~ (AC), 50 Hz
38 W
(DC)
12 .6 V
2 .4 A
approx . 60 min
2 A T2A
II / (double insulation)
= 83 dB(A)
PA
= 3 dB
PA
= 94 dB(A)
WA
= 3 dB
WA
2
2
WARNING!
► Depending on the manner in which the pow-
er tool is being used, and in particular the
kind of workpiece that is being worked, the
vibration and noise emission values can devi-
ate and may, in many cases, be higher than
the values given in these instructions . Regular
use of the power tool in this way may cause
the user to underestimate the vibration . Try to
keep the vibration loads as low as possible .
Measures to reduce the vibration load are,
e .g . wearing gloves and limiting the working
time . Wherein all states of operation must be
included (e .g . times when the power tool is
switched off and times where the power tool
is switched on but running without load) .
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions, illust-
rations and specifications provided with this
power tool. Failure to follow all instructions
listed below may result in electric shock, fire
and/or serious injury .
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents .
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .
GB │ IE │ NI │ CY │ 3 ■