Included Items; Technical Information; General Safety Advice For Electrical Power Tools; Workplace Safety - Parkside PHKS 66 Bedienungs- Und Sicherheitshinweise

Guide fence
15
Riving knife
16
Sawdust removal connector
17
Adapter for vacuum sawdust removal
18
Cutting depth scale
19
Auxiliary handle
20
Drive spindle
21
Mounting flange
22
Clamping flange
23
Clamping screw with plain washer
24
Riving knife mounting
25
Mounting screws
26

Included items

Q
1 Circular saw
1 Guide fence
1 Adapter for vacuum sawdust removal
1 Allen key
1 Operating instructions

Technical information

Q
Rated power:
Rated voltage:
No-load rotational speed: n
Saw blade:
Cutting depth:
Protection class:
Noise and vibration data:
Values determined in accordance with EN 60745
The sound pressure level (A-weighted) of the device
is typically 96 dB (A). Uncertainty K = 3 dB. The
sound level while working can exceed 110 dB (A).
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1,5 m / s
Introduction / General safety advice for electrical power tools
1.300 W
230 V ~ , 50 Hz
2.200 – 5.200 min
0
190 x 30 x 1.8
(2.6 mm tooth thickness)
66 mm
II /
= 3,447 m / s
2
2
WarNING!
instructions has been measured in accordance with
a standardised measurement procedure specified in
EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vi-
bration levels and in many cases they may exceed the
values given in these instructions. It is easy to under-
estimate the vibration load if the electrical power
tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety advice for
electrical power tools
WarNING!
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC-
-1
TIONS IN A SAFE PLACE FOR FUTURE REFER-
ENCE! THE TERM "ELECTRICAL TOOL" USED
IN THE SAFETY ADVICE REFERS TO ELECTRICAL
TOOLS POWERED BY MAINS ELECTRICITY (BY
MEANS OF A MAINS LEAD) AND ELECTRICAL
TOOLS POWERED BY RECHARGEABLE BATTER-
IES (WITHOUT A MAINS LEAD).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
Do not work with the device
b)
in potentially explosive envi-
ronments in which there are
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
The vibration level given in these
read all the safety advice
GB 7