Rip Fence; Connecting A Dust Extraction Unit; Use; Switching On And Off - Parkside PHKSA 12 A1 Originalbetriebsanleitung

4 . Undo the tensioning screw
5 . Now, remove the tensioning screw
clamping flange
Fig. A: Changing the saw blade
6 . Pull the blade guard
the release lever
in this position .
7 . Remove the saw blade
appliance from below .
5 . Fitting a saw blade
order .
6 . Press the spindle lock button
and use the hex key
screw .
WARNING!
► The arrow on the saw blade
spond to the arrow showing the direction of
rotation (running direction shown on the
blade guard ) .
■ Ensure that the saw blade
rotational speed of the tool .

Rip fence

♦ Undo the wing screw for the rip fence
place the rip fence
♦ Set the desired cut width
using the scale on the rip fence
out in the base plate
The right recess in the base plate is for a cutting
angle of 0° . The left recess in the base plate is
for a cutting angle of 45° .
PHKSA 12 A1
using a hex key
and the
(see also fig . A) .
all the way back using
and keep the blade guard
carefully out of the
is done in the reverse
(until it engages)
to tighten the clamping
must corre-
is suitable for the
and
in the rip fence slot
and the cut
(see also fig . B) .
.
Fig. B: Cutting width 2 cm
♦ Retighten the wing screw for the rip fence

Connecting a dust extraction unit

♦ Attach the adapter for dust extraction
chip ejector
Optional depending on the diameter of the dust
and sawdust extraction .
♦ Connect an approved dust and chip extraction
device .
NOTE
► When sawing wood or other materials that
create dusts that are hazardous to health,
always connect the appliance to a suitable,
certified suction appliance .

Use

Switching on and off

Switching on:
♦ Push the safety lock-out
and keep it pressed .
♦ Press the ON/OFF switch
light lights up . Once the saw is running, you
can release the safety lock-out
Switching off:
♦ Release the ON/OFF switch
.

Battery charge level

♦ The status will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Overload warning

♦ If the appliance is in danger of overloading,
the overload warning
appliance switches off .
.
to the left or right
. The LED work
.
.
lights up briefly . The
GB │ IE │ NI │ CY
.
to the
│ 9 ■