Safety Information For Circular Saw Blades; Original Accessories/Auxiliary Equipment; Before Use; Removing/Charging/Inserting The Battery Pack - Parkside PHKSA 12 A1 Originalbetriebsanleitung

■ Do not allow the teeth of the saw blade to
overheat .
■ When sawing plastic, avoid melting the plastic .
■ Wear a dust mask when sawing .
■ Only use recommended saw blades .
■ Always wear hearing protection!
Safety information for circular saw
blades
Wear protective gloves!
Wear a dust mask!
Wear protective goggles!
Wear hearing protection!
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries.
Original accessories/auxiliary
equipment
■ Only use the accessories and additional
equipment that are specified in the oper-
ating instructions and compatible with the
appliance.

Before use

Removing/charging/inserting the
battery pack
CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the charger .
■ 8 │ GB │ IE │ NI │ CY
■
1 . To remove the battery pack
2 . Insert the battery pack
3 . Insert the mains plug into the socket . The control
4 . The green charge status indicator LED
5 . Insert the battery pack

Checking blade guard functionality

♦
The blade guard
When letting go of the release lever for the blade
guard
original position .

Operation

from or connect

Fitting/changing the saw blade

Always remove the battery pack before changing
the saw blade
1 . Set the cutting depth (using the locking screw
2 . Swing the blade guard
3 . Press the spindle lock button
NOTE
► The battery is supplied partially charged .
Before first use, charge the battery in the
charger for at least 1 hour . This guarantees
full battery performance . You can charge the
lithium-ion battery at any time without short-
ening its service life . Interrupting the charging
process does not damage the battery .
► If the battery overheats during operation, it
cannot be charged immediately . Allow it to
cool down first .
Never charge the battery pack
ambient temperature is below 10°C or above
40°C .
button and pull the battery pack
appliance .
charger .
LED lights up red .
that the charging process is complete and the
battery pack is ready .
Pull the release lever for the blade guard
far as it will go .
should move without jamming .
, it should automatically jump back to its
!
to the minimum position, 0 mm .
release lever and put the appliance down .
es) and hold it in .
if the
, press the release
out of the
into the high-speed
indicates
back into the appliance .
as
back using the
(until it engag-
PHKSA 12 A1
)