Safety Instructions For All Applications - Parkside PFBS 12 B3 Originalbetriebsanleitung

Safety instructions for all applica-
tions
General safety instructions for grinding, sand-
paper sanding, working with wire brushes,
polishing, milling and abrasive cutting:
a) This power tool is intended for use as a grinder,
sandpaper sander, wire brush, polisher, milling
machine and abrasive cutting machine.
Please follow all safety instructions, instruc-
tions, diagrams and data that you receive
with the appliance. If you do not observe the
following instructions, this can lead to electrical
shock, fire and/or serious injuries.
b) Do not use any accessories that have not
been provided or recommended by the manu-
facturer for this power tool. Just because you
can attach the accessories to your power tool,
does not ensure they are safe to use.
c) The permissible speed of the accessory tool
used must be at least as high as the maximum
speed specified for the power tool. Accessories
that rotate faster than the permissible rate can
break and throw pieces into the air.
d) The external diameter and thickness of the
accessory tool used must comply with the
dimensions of your power tool. Incorrectly
dimensioned accessory tools cannot be suffi-
ciently shielded or controlled.
e) Grinding discs, sanding drums or other acces-
sories must match the grinding spindle or
collet chuck of your power tool exactly.
Accessory tools which do not fit precisely into
the take-up of the power tool will rotate unevenly,
vibrate severely and can lead to a loss of control.
│ GB │ IE
■ 22
f) Discs, grinding cylinders, cutting tools or
other accessories mounted on a mandrel must
be completely inserted in the collet or chuck.
Any "protrusion" or exposed parts of the
mandrel between the grinding tool and the
collet or chuck must be kept to a minimum. If
the mandrel is not sufficiently tightened or the
grinding tool protrudes too far, the tool could
come loose and be thrown out at high speed.
g) Never use damaged accessory tools. Before
each use, check accessory tools such as
grinding discs for chips or cracks, sanding
drums for cracks or excessive wear and tear
and wire brushes for loose or broken wires.
If the power tool or the accessory tool in use
is dropped, check to see if it is damaged or
use an undamaged accessory tool. When
you have checked and inserted the accessory
tool, ensure that you and any other people
in the vicinity remain outside of the range of
the rotating accessory tool and allow the tool
to rotate at maximum speed for one minute.
Damaged accessory tools usually break during
this test period.
h) Wear personal protective equipment.
Depending on the application, ensure that
you use full face protection, eye protection
or goggles. If required, use a dust mask, ear
protectors, protective gloves or a special
apron to protect you from grindings and
material particles. Protect your eyes from
flying debris that may be created during certain
applications. Dust or filter masks must be used
to filter any dust created by the application.
If you are exposed to loud noise for any length
of time, you may suffer hearing loss.
i) Ensure that other people remain at a safe
distance from your workspace. Anyone who
enters the workspace must wear personal
protective equipment. Fragments of the work-
piece or broken accessory tools can fly off
and cause injury – even outside the immediate
working area.
PFBS 12 B3