What Is What - Husqvarna RC 455 Bedienungsanweisung

Operator's Manual RC 455

What is what

3
8
2
1. Incoming hydraulic connections
The hoses from the hydraulic unit are connected to
these 3/4-inch couplings. This is the machine's input
flow. The flow in the hose connected to the female
coupling (1a.) drives the tool, while the flow through the
male coupling (1b) is the return flow to the hydraulic
unit.
2. Outgoing hydraulic connections
The supplied hydraulic hoses are connected to these.
These are then connected to suitable hydraulic tools.
The large couplings control the drive of the attached
tool while the smaller control the blade and trolley
motion. The flow in the hoses with female couplings
control the trolley motion while the male couplings
control the blade motion.
3. Canbus cable connection
The Canbus cable that sends the control signals
between RC 455 and the remote control is connected
here. The Can bus cable is equipped with a locking
mechanism so the cable is not loosened
unintentionally.
4. 12 volt DC connection
The power that drive RC 455 is connected here. The
power is appropriately taken from the hydraulic unit
used together with RC 455. The connection is
equipped with a locking mechanism so that the cable
is not loosened unintentionally.
4
1a
7
1b
6
5
16
12
13
The 12 volt cable is supplied from the factory with a
"Pig tail". This is connected by the operator to the
available Hydraulic unit. See also under "Assembling/
Installing equipment"
5. Automatic fuse
Trips when the incoming 12 volt DC current is too high.
Press in to reset.
6. Feet
Protect the machine against vibrations and dirt.
7. Incoming water connector
8. Outgoing water connector
9. Remote control
The remote control is used to control RC 455. In order
for the remote control to work the hydraulic unit's
ignition must be switched on.
10.Flow off/on
This is the only control from which the hydraulic unit
can start the hydraulic flow.
Pressing the control once brings the hydraulic unit up
to working speed and it starts to produce a flow. Stop
the flow by pressing the start button once again or
press in the emergency stop button on the left-hand
side of the remote control.
What is what
9
11
14
15
English - 9
10