Menu Functions; Start Menu; Operations Menu - Husqvarna RC 455 Bedienungsanweisung

Operator's Manual RC 455
10.The output tension on the magazine is shown by an
indicator on the machine (shown in the min position).
When the magazine cylinder is fully tensioned, the
machine must be stopped and the wire must be wound
around a new wheel set. Then continue to cut as
above.
CAUTION
Always clean all the equipment at the end of
the working day

Menu functions

The menus, shown on the display, are grouped in menus,
sub-menus ("Settings") and part menus. The menus are
divided into two sections:
• Start menu: Here you can select under which
conditions the hydraulic unit shall work.
• Operations menu: Information concerning the
operating status is shown here.

Start menu

The start menu is shown each time the power to the
hydraulic unit is switched on. The display shows:
SMARTBOX Connect hose assembly
• Press OK when all hoses are connected. Step 2 is then
displayed.

Operations menu

The operations menu starts after the hoses have been
connected and the operator confirms with "OK". All
information about operations and all setting options are
accessed from this menu.
The operations menu consists of seven menus:
1. 1a. Husqvarna PP-455, 1b Status
2. Settings
3. Time
4. Total machine time
5. Battery status (only machines equipped with a radio)
6. Radio channel (only machines equipped with a radio)
1.a. Husqvarna SMARTBOX, Start motor
Press the green button on the remote control to start
the motor.
1b. Status
Status is the main information that is always shown on
the display when hydraulic unit with connected
machine is operational:
• STATUS OK, signifies that the unit is operational and
no warning messages have been issued.
• yyy BAR, where yyy represents the instantaneous
operating pressure.
• When time is switched on:
mm:ss, is also shown, i.e. the time in minutes and
seconds.
Menu functions
English - 15