Husqvarna RC 455 Bedienungsanweisung Seite 10

What is what
11.Blade rotation
Control to start blade rotation/wire drive. In order for
the blade to reach full power, the control must be
turned to the right-hand end position.
12.Display
Information is given on the display about essential
settings, service requirements and any faults.
When working, the display shows the current main
pressure for blade rotation (not the motion pressure).
13.Blade motion
Control for moving the blade. From here you control the
blade motion or the wire tension when wire cutting.
14.Trolley motion
Control for horizontal motion of the saw unit. The
direction and speed are controlled from here. When the
horizontal motion is increased, the blade rotation
pressure also increases. This can be read on the
display.
15.Option keys
The arrow keys are used to:
• Scroll through the menus.
• Increase/decrease numerical values.
The "OK" confirmation key is used to:
• Open sub-menus.
• Confirm values that have been adjusted with the keys.
• Switch on/switch off sensors.
16.Emergency stop
There is an emergency stop switch located on the side
of the remote control. When the emergency stop switch
is pressed in the attached tool stops working and the
hydraulic unit starts to idle.
10 - English
Operator's Manual RC 455